Campbell CS-GSM/GPRS Guide de l'utilisateur

Naviguer en ligne ou télécharger Guide de l'utilisateur pour Mise en réseau Campbell CS-GSM/GPRS. Campbell CS-GSM/GPRS User guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
CS-GPRS
Communications Package
User Guide
Preliminary
Issued 22.7.08
Copyright
©
2008 Campbell Scientific Ltd.
CSL 796
Vue de la page 0
1 2 3 4 5 6 ... 21 22

Résumé du contenu

Page 1 - Communications Package

CS-GPRS Communications Package User Guide Preliminary Issued 22.7.08 Copyright © 2008 Campbell Scientific

Page 2

CS-GPRS Communications Package 4 baud rates may be possible, depending on the modem being used, its set-up and how busy the network is locally. See

Page 3 - Guarantee

User Guide 5 Once the port/baud rate is set you will find the main PPP settings under the Deployment, TCP/IP tab. You need to enter your username a

Page 4

CS-GPRS Communications Package 6 Hyperterminal. The setting can also be sent from the datalogger program itself (contact CS for details of how to do

Page 5 - Contents

User Guide 7 7. General Principles of Operation Once the PPP setting is enabled on a giving serial port the datalogger will immediately try to est

Page 6

CS-GPRS Communications Package 8 7.2 Using systems with dynamic IP addresses If you have a dynamic IP SIM (as is standard on most networks) you will

Page 7 - 1. Introduction to GPRS

User Guide 9 7.3 Keeping the connection open Once a connection between the logger and the Loggernet PC is established, Pakbus messaging will keep

Page 8 - 2. Hardware

CS-GPRS Communications Package 10 every 30 minutes or set up another process, e.g. low frequency pinging, to keep the connection active. It should be

Page 9 - 4. Datalogger firmware

User Guide 11 By implication the logger defaults to the PPPOpen state as soon a port is activated for PPP. This is not dependent on a program runni

Page 10

CS-GPRS Communications Package 12 Note that Device Configuration program only reads these settings once when the program starts. If you wish to mon

Page 11

User Guide 13 If the PPP link works (i.e. you get an non-zero IP address in the screen above) but you do not get a connection to Loggernet, check th

Page 15

CAMPBELL SCIENTIFIC COMPANIES Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci

Page 16 - 7.4 Firewall Issues

Guarantee This equipment is guaranteed against defects in materials and workmanship. This guarantee applies for twelve months from date of delivery. W

Page 18

i Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to spe

Page 20

1 CS-GPRS Communications Package This manual is designed to act as an addendum to the CS-GSM manual that describes general use of the Wavecom Fastrac

Page 21

CS-GPRS Communications Package 2 • Can do a one way transmission to Loggernet or another logger (Senddata) • Can open virtual serial ports to other

Page 22

User Guide 3 For full flexibility specialist suppliers provide a service to give individual devices a fixed IP address, which can either be private,

Commentaires sur ces manuels

Pas de commentaire