Campbell RavenXTV CDMA Manuel télécharger pdf (Page 23)

RavenXTV CDMA Sierra Wireless Cellular Modem

4. For PakBus dataloggers, leave the default settings on the PakBusPort page.

“PakBus Port Always Open” should not be checked.

5. For PakBus dataloggers, set the PakBus address to match that of the

datalogger (default address in the datalogger is 1). Click the “Apply”

button to save the changes.

6.1 Test the Cellular Connection

After the Device Map has been configured, test the cellular connection using

the “Connect” screen as shown below. Click on the appropriate station, then

click the “Connect” button to initiate a call to the datalogger. If the call is

successful, the connectors at the bottom of the screen will come together, and

time information from the datalogger displayed will be the “Station

Date/Time” field. If the connection fails, a “Communications Failure”

message is displayed. Troubleshooting procedures can be found in Section 7,

Troubleshooting, and Appendix D, Troubleshooting Flowchart.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Pas de commentaire

Campbell RavenXTV CDMA Manuel Page 23