Campbell RF500M Spécifications télécharger pdf (Page 10)

Section 2. Radiotelemetry Network Components

Depending on the radio being used, the appropriate internal jumper must be

selected on the RF500M circuit board. There is a set of six jumpers in series

located just under the Campbell Scientific, Inc. name and circuit board version

number etched on the board. When looking at the front panel with the three

ports, the jumpers that need to be set are located in the back, right corner of the

circuit board. The two jumpers next to the edge of the circuit board should be

selected if using the RF310 series radios. The two jumpers in the center

should be selected if using the RF300 series radios. The two jumpers on the

inside of the board should be selected if using an unmodified DataRadio DL-

3400 radio.

FIGURE 2-2. RF500M Radio Jumper Location

2-4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Pas de commentaire

Campbell RF500M Spécifications Page 10