Campbell CM10 Manuel d'installation télécharger pdf (Page 8)

Section 1. Preparation and Siting

1.2 Tools Required

Tools required to install and maintain a weather station are listed below.

1.2.1 Tools for Tripod Installation

Shovel

Rake

Open end wrenches: 3/8", 7/16", ½", (2) 9/16"

Magnetic compass

6' Step ladder

Tape measure (12')

Level (12" to 24")

Small sledge hammer

Teflon tape or pipe dope

Allen hex wrench (5/64)

1.2.2 Tools For Instrumentation and Maintenance

Lock and key for enclosure

Magnetic declination angle (Section 4.19)

Magnetic compass

Straight bit screwdrivers (small, medium, large)

Phillips-head screwdrivers (small, medium)

Small diagonal side-cuts

Needle-nose pliers

Wire strippers

Pocket knife

Calculator

Volt / Ohm Meter

Electrical Tape

Step ladder (6')

Station manuals

Station log and pen

Open end wrenches: 3/8", 7/16", ½", (2) 9/16"

Socket wrench and 7/16" deep well socket

Adjustable wrench

Pliers

Conduit and associated tools (as required)

Felt-tipped marking pen

Claw hammer

Pipe wrench (12")

Tape measure (12')

Level (12" to 24")

Teflon tape or pipe dope

1-2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

Pas de commentaire

Campbell CM10 Manuel d'installation Page 8