Campbell SP-LITE Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Mesure, test et contrôle Campbell SP-LITE. SP LITE Manual - Campbell Scientific Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 23
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
INSTRUCTION MANUAL
Copyright © 2007
Campbell Scientific (Canada)Corp.
SP-LITE Silicon Pyranometer
May 2007
Vue de la page 0
1 2 3 4 5 6 ... 22 23

Résumé du contenu

Page 1 - INSTRUCTION MANUAL

INSTRUCTION MANUALCopyright © 2007Campbell Scientific (Canada)Corp.SP-LITE Silicon PyranometerMay 2007

Page 2

SP-LITE Silicon Pyranometer 4 2. Sensor Specifications Electrical Nominal Impedance: <50 Ω Response Time: <1 second Sensitivity: (see Cert

Page 3 - WARRANTY AND ASSISTANCE

SP-LITE Silicon Pyranometer 5 3. Installing the SP-LITE The SP-LITE and CLF1 base/leveling fixture are attached to a tripod or tower using one of two

Page 4

SP-LITE Silicon Pyranometer 6 FIGURE 7. 025 STAND and 019 Crossarm Mount the sensor on the mounting arm at a height of at least 1.5 m above the grou

Page 5 - SP-LITE Table of Contents

SP-LITE Silicon Pyranometer 7 4. Wiring The SP-LITE can be measured with a differential or single-ended channel on the datalogger; a differential chan

Page 6

SP-LITE Silicon Pyranometer 8 5.1 Datalogger Input Range Codes Normally the 500 mV range for the 21X and CR7, the 250 mV range for the CR10(X) and CR5

Page 7 - SP-LITE Silicon Pyranometer

SP-LITE Silicon Pyranometer 9 EXAMPLE 1. Sample Instructions used to Measure an Average Flux with a CR10X ;{CR10X} ; *Table 1 Program 01: 10 Execu

Page 8 - 1.2 Spectral Properties

SP-LITE Silicon Pyranometer 10 5.4 Program Example 2, Total Solar Radiation In Example 2 a daily total flux density is found. This total flux densit

Page 9

SP-LITE Silicon Pyranometer 11 EXAMPLE 2. Sample Instructions used to Measure a Daily Total Flux Density with a CR10X ;{CR10X} ; *Table 1 Program 01

Page 10 - 2. Sensor Specifications

SP-LITE Silicon Pyranometer 12 6. Maintenance The SP-LITE is an ‘all weather’ instrument and is very stable, but should be handled with care. It requi

Page 13 - 5. Datalogger Programming

SP-LITE Silicon Pyranometer 13 APPENDIX B

Page 14

Page 1 April 6, 2006 CLF1 Leveling Base with 015 Mounting Arm To install the CLF1 leveling base onto the 015 mounting arm, a set of three screw

Page 15

Page 2 April 6, 2006 Use the three screws to attach the CLF1 to the 015 loosely.

Page 16

Page 3 April 6, 2006 Set of 2 SP LITE fixing bolts included with the CLF1. Use the set of 2 SP LITE fixing bolts to mount the SP LITE to the C

Page 17

WARRANTY AND ASSISTANCE This equipment is warranted by CAMPBELL SCIENTIFIC (CANADA) CORP. (“CSC”) to be free from defects in materials and wor

Page 19 - APPENDIX A

i SP-LITE Table of Contents 1. General Description...1 1.1 Electrical Properties...

Page 21

1 SP-LITE Silicon Pyranometer The SP-LITE measures incoming solar radiation (sun plus sky radiation) with a photodiode detector. Output from the phot

Page 22

SP-LITE Silicon Pyranometer 2 FIGURE 2. SP-LITE Electrical Circuit 1.2 Spectral Properties The spectral properties of the SP-LITE are mainly determi

Page 23

SP-LITE Silicon Pyranometer 3 Both the spectral sensitivity and the photodiode sensitivity of the SP-LITE will change with temperature, and the separa

Commentaires sur ces manuels

Pas de commentaire