Campbell COM220 Guide de l'utilisateur télécharger pdf (Page 10)

Call-Back Configuration for the CR800/CR1000 – MultiLogger Application Note #19 – Page 10 of 12

Configure the Task Name as appropriate to help identify the Task. Use the file open button to browse

to the executable to run, in this case Roobrik. Enclose the executable in quotes when using command

line parameters, the parameters direct Roobrik to load the mychart parameter file, then GO! and Quit.

See the Roobrik User’s Guide section 2.3 for more information on the Roobrik command line parameters.

Optionally additional tasks can be configured and selected using the After Task Do drop-down.

Configured tasks will display in the drop-down. Use the Run this task after collect data for this

gateway to run the Task after a scheduled data collection.

Next, configure the logger node to execute the Task. Select the logger node in the Network Configuration

and use the After Call-back Do drop-down to select the task. You may also select other logger nodes for

data collection to automate data collection from other loggers in the event of call-back from one logger.

See the following section on starting the Agent to handle the call-back events.

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Campbell COM220 Guide de l'utilisateur Page 10