Campbell Raven II Manuel d'instructions

INSTRUCTION MANUAL Raven XT-RogersSierra Wireless Cellular Modem Dec 2011Copyright © 2010Campbell Scientific (Canada)Corp.

Raven XT-Rogers Sierra Wireless Cellular Modem Wiring: Red 12V (or switched 12V)Black G White Not Used L10873 serial cable provided w

Raven XT-Rogers Sierra Wireless Cellular Modem • PN L14394 Raven Mounting Kit—includes mounting hardware for securing the modem to below referenced e

Raven XT-Rogers Sierra Wireless Cellular Modem PN C2445 9dBd Directional Yaggi Antenna PN L21831 Half-Wave Dipole Whip Antenna FIGURE 4.2-2. Antenn

Raven XT-Rogers Sierra Wireless Cellular Modem The template files are available from Campbell Scientific’s Website: http://www.campbellsci.ca/download

Raven XT-Rogers Sierra Wireless Cellular Modem Template files are available from Campbell Scientific’s Website: http://www.campbellsci.ca/download.

Raven XT-Rogers Sierra Wireless Cellular Modem Click on EDGE/HSDPA Group to get the following screen: For a data account with the VPN.COM APN, enter

Raven XT-Rogers Sierra Wireless Cellular Modem will then be the address for the Raven’s configured name. Once the Raven’s IP has been updated in IP M

Raven XT-Rogers Sierra Wireless Cellular Modem • Can include a hyphen (-) • Cannot contain spaces • Must be no longer than 20 characters total Cli

Raven XT-Rogers Sierra Wireless Cellular Modem Light Patterns The LEDs on the front of the modem will respond in different patterns to indicate modem

Raven XT-Rogers Sierra Wireless Cellular Modem LoggerNet Device Map For a Dynamic IP using Sierra Wireless’s IP Manager (Section 5.2), enter the inter

WARRANTY AND ASSISTANCE This equipment is warranted by CAMPBELL SCIENTIFIC (CANADA) CORP. (“CSC”) to be free from defects in materials and wor

Raven XT-Rogers Sierra Wireless Cellular Modem In some cases where signal strength is low, you may have to decrease the packet size of the CR1000.

Raven XT-Rogers Sierra Wireless Cellular Modem The Device Port gets changed from the default 12345 to 6785 when the template file is loaded into the

Raven XT-Rogers Sierra Wireless Cellular Modem Connect to the modem with AceManager (Section 5.3). Select the “Serial” Group, and make sure the “AT

Raven XT-Rogers Sierra Wireless Cellular Modem Verify the APN has been entered in the NETAPN and +CGDCONT fields as shown above (where VPN.COM is the

Raven XT-Rogers Sierra Wireless Cellular Modem 7.2 Verify Connections at the Datalogger Verify the modem is connected to 12 V and the power led is on

Raven XT-Rogers Sierra Wireless Cellular Modem 7.3 LoggerNet/PC400W Device Map Check your LoggerNet setup. a. Make sure the port number at the end o

Raven XT-Rogers Sierra Wireless Cellular Modem 7.4 Using AceManager to Check Modem Communications with Datalogger The modem’s “Host Serial Bytes Sent

Appendix A. Wireless Ace Setup without Template File Wireless Ace 3G is used to program settings in the Raven XT-Rogers modem to make the modem compa

Appendix A. Wireless Ace Setup without Template File • S23 – Configure Serial Port – The baud rate needs to be configured to match a valid datalogge

Appendix A. Wireless Ace Setup without Template File • S0 – TCP Auto Answer – Set to On • TCPT – TCP Idle Timeout -- Set to a reasonable value lik

Raven XT-Rogers Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmar

Appendix A. Wireless Ace Setup without Template File A-4 This is a blank page.

Appendix B. Installation of SIM Card in the RavenXT-Rogers The Subscriber Identity Module (SIM) in the Raven XT-Rogers is a smartcard securely storin

Appendix B. Installation of SIM Card in the RavenXT-Rogers 4. Replace the faceplate; the installation of the SIM is complete. B-2

Appendix C. Configuring the Raven XT-Rogers for PPP The Raven XT-Rogers template file configures the Raven XT-Rogers to function as a serial server.

Appendix C. Configuring the Raven XT-Rogers for PPP Use AceManager to configure the following Misc setting: • DPort = 3001 (Changed from 6785) This

Appendix C. Configuring the Raven XT-Rogers for PPP Using the Device Configuration Utility, select the “Net Services” tab. The “PakBus/TCP Service

Appendix C. Configuring the Raven XT-Rogers for PPP LoggerNet Settings: Enter the IP address of the Raven XT-Rogers, and the PakBus/TCP Service Port

Appendix C. Configuring the Raven XT-Rogers for PPP Example CR1000 Program The following example sends an email message when an alarm condition is Tr

Appendix C. Configuring the Raven XT-Rogers for PPP C-6 This is a blank page.

Raven XT-Rogers Table of Contents ii Figures 4.2-1. Modem Interface Options...4-6 4.2-2

1 Raven XT-Rogers Sierra Wireless Cellular Modem 1. General Description This%manual%provides%information%for%interfacing%the%Sierra%Wireless%Raven%XT

Raven XT-Rogers Sierra Wireless Cellular Modem When completed Rogers should provide you with the following information: 10-digit MSISDN number (used

Raven XT-Rogers Sierra Wireless Cellular Modem 4. Configuration 4.1 Base Station Requirements for Raven XT-Rogers • A PC running Campbell Scientif

Raven XT-Rogers Sierra Wireless Cellular Modem Wiring: Red 12V (or switched 12V) Black G White Not Used PN L18663 PN 18663 Null Modem Cable—

Raven XT-Rogers Sierra Wireless Cellular Modem Wiring: Red 12V (or switched 12V) Black G White Not Used L10873 serial cable provided with th