Campbell Raven II Guide de l'utilisateur télécharger pdf (Page 30)

SAA CR Logger Integration Guide

May 2012 25

' Enter the number of Strain Gages (SG) to be monitored:

Const NUM_SGS = 20

'>>>>>>>>>>>>>>> START <<<<<<<<<<<<<<<

' Enter the number of raw data samples to average for each measurement:

' Samples can range from 100-25500; samples are collected at 400 Hz, thus ~64 seconds are required for

NUM_TO_AVG = 25500

Const NUM_TO_AVG = 1000

'>>>>>>>>>>>>>>> END <<<<<<<<<<<<<<<

'>>>>>>>>>>>>>>> START <<<<<<<<<<<<<<<

' Enter the maximum number of octets (8 segment units) of any single SAA being used:

Const MAX_NUM_OCTETS = 15

' Enter the maximum number of PZs of any single PZ string being used:

Const MAX_NUM_PIEZOS = 1

'>>>>>>>>>>>>>>> END <<<<<<<<<<<<<<<

'>>>>>>>>>>>>>>> START <<<<<<<<<<<<<<<

' Enter number of octets for each SAA (each SAA must have an entry):

Const SAA1_NUM_OCTETS = 15

Const SAA2_NUM_OCTETS = 15

'>>>>>>>>>>>>>>> END <<<<<<<<<<<<<<<

'>>>>>>>>>>>>>>> START <<<<<<<<<<<<<<<

' Enter COM port index for each SAA (each SAA must have an entry) COM1=1, COM2=2, COM3=3, COM4=4,

RS232=5

Const SAA1_COM_PORT = 1

Const SAA2_COM_PORT = 2

'>>>>>>>>>>>>>>> END <<<<<<<<<<<<<<<

'>>>>>>>>>>>>>>> START <<<<<<<<<<<<<<<

'Enter SAA232-5 port number for each SAA (each SAA must have an entry) 1-5 if SAA232-5 port is being used,

otherwise enter 0

Const SAA1_232_5_PORT = 0

Const SAA2_232_5_PORT = 0

'>>>>>>>>>>>>>>> END <<<<<<<<<<<<<<<

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 42 43

Pas de commentaire

Campbell Raven II Guide de l'utilisateur Page 30