Campbell CVF4 Manuel d'instructions télécharger pdf (Page 19)

CMP6-L, CMP10-L, CMP11-L, and CMP21-L Pyranometers

Figure 7-3 Exploded view of the pyranometer mounting

7.2 Wiring

Short Cut users should wire the sensor according to the wiring

diagram generated by Short Cut.

The cable of the CMP6, CMP10 and CMP11 has two conductors and a shield.

The cable of the CMP21 has five conductors and a shield. The additional

conductors on the CMP21’s cable are for connecting its internal thermistor. A

schematic for the CMP6, CMP10, CMP11, and the thermopile of the CMP21 is

provided in Section 7.2.1 CMP6, CMP11, and CMP21 Thermopile Schematic.

Wiring for the CMP6, CMP10, and CMP11 is described in Section 7.2.2,

CMP6 and CMP11 Wiring, wiring for the CMP21 is described in Section 7.2.3,

CMP21 Wiring.

Note

Mounting screws

Levelling screw

CM245

mounting stand

Pyranometer

Crossarm

Bubble level

Nylon washers

Sun shield

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Pas de commentaire

Campbell CVF4 Manuel d'instructions Page 19