Campbell AVW200 series Manuel d'instructions télécharger pdf (Page 37)

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules

FIGURE 5-2. Deployment Communications Editor in DevConfig

Certain AVW206 settings must match the RF401 settings for

communications between the interface and radio to be successful.

Description of the Communication Settings follows:

Protocol—choose “PakBus” for the “Protocol” setting. Please note that the

“Protocol” setting for the RF401-series radio must be set to either “PakBus

Aware” or “PakBus Node” for communications to be successful.

PakBus Address—enter a PakBus Address that matches the PakBus address

specified in the CRBasic program that will control the AVW200. Each device

in a PakBus network must have a unique address. Valid settings are 1–4094.

RS-232 Baud Rate—enter the baud rate in which you want to communicate.

Hop Sequence—enter the radio “Hop Sequence” that matches all of the RF401

radios and other AVW206 Interfaces in the network. Valid entries are 0–6.

NOTE

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 113 114

Pas de commentaire

Campbell AVW200 series Manuel d'instructions Page 37