Campbell AVW200 series Manuel d'instructions télécharger pdf (Page 40)

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules

Multiplexer Type—choose the appropriate multiplexer. The default

multiplexer type is the AM16/32B.

Begin Frequency—if using RS-232 (terminal commands) or SDI-12, enter the

sensor manufacturer’s recommendation for the begin frequency.

End Frequency—if using RS-232 (terminal commands) or SDI-12, enter the

sensor manufacturer’s recommendation for the end frequency.

Excitation—if using RS-232 (terminal commands) or SDI-12, choose either

“5 Volts Peak-Peak” or “12 Volts Peak-Peak” excitation. Use the sensor

manufacturer’s recommendation for the excitation.

Once the settings have been defined, press Apply to save the changes to the

AVW200.

5.3 Data Monitor

The Data Monitor tab in DevConfig can display either the Public Table or

Status Table. The public table displays the current sensor measurement values

as well as the current settings (see FIGURE 5-4).

FIGURE 5-4. Data Display/Public Table in DevConfig

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 113 114

Pas de commentaire

Campbell AVW200 series Manuel d'instructions Page 40