Campbell CM375 Manuel d'instructions télécharger pdf (Page 21)

CM375 Portable 10-Meter Mast

FIGURE 3-19. Installed lightning rod

Step 4: Assemble enclosures, sensors and tie cables to mast, as required.

3.4 Anchor Installation

FIGURE 3-20. Tape measure in slot for South anchor

Step 1: For the South anchor, place tape measure into slot in base centering

tape within notch on edge of base. Measure to 20 ft (see FIGURE 3-20).

Step 2: At 20 ft, install the duckbill anchor with drive rod (see FIGURE 3-21).

The anchor needs to be driven into the ground at a 45° angle (see FIGURE

3-22). Drive anchor until the loop or metal ring is several inches above the

ground.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Pas de commentaire

Campbell CM375 Manuel d'instructions Page 21