Campbell CM375 Manuel d'instructions télécharger pdf (Page 24)

CM375 Portable 10-Meter Mast

Step 6: Attach guy wires to anchors by first opening the turnbuckle to the

widest setting. Attach turnbuckle to wedge end of the guy cable, and then

attach the other end of the turnbuckle to an anchor (see FIGURE 3-25).

FIGURE 3-25. Turnbuckle fastened to guy cable and anchor

Step 7: If using rope ratchet to assist assembly, set to 7 feet and attach to

tension clamp on cable and to anchor end. Do this for both NE and NW

anchors and top and bottom guy cables (see FIGURE 3-26 and FIGURE 3-27).

Do not connect the SOUTH cables at this time.

FIGURE 3-26. Top and bottom guy cables fastened to an anchor

NOTE

Guy Cable Wedge

Ancho

Open turnbuckle to widest setting.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Campbell CM375 Manuel d'instructions Page 24