Campbell RF410 Manuel d'instructions Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 124
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
PakBus Networking Guide
14
i. Highlight CR205_3 and change PakBus Address to 3.
FIGURE 9. CR205_3 Setup
Step 11 – Set up Network Hardware
a. Verify the following:
9 Antennas are on RF400s and CR205s.
9 12V supply is connected to base RF400
9 Base RF400’s RS-232 port is attached by SC12 cable to PC COM
port
b. Cable the ‘router’ RF400’s CSI/O port to the CR10XPB.
c. Place CR10XPB/RF400 and CR205s within range of each other.
PC
RF400
(base)
RF400
(remote)
CR10XPB_1
(router)
CR205_2
CR205_3
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 123 124

Commentaires sur ces manuels

Pas de commentaire